Page 1 of 2
Oil capacity and grades
Posted: Sun Mar 17, 2013 1:03 pm
by Darrell
This is from the SJ413 workshop manual.
- Diff oil level.jpg (42.47 KiB) Viewed 33602 times
- Transfer oil level.jpg (38.74 KiB) Viewed 33602 times
- Gearbox oil level.jpg (46.82 KiB) Viewed 33602 times
The 410 is the same apart from - 4 speed gearbox capacity is 1L.
Re: Oil capacity and grades
Posted: Fri Jul 10, 2015 10:42 pm
by courior
Is the 410 5 speed still 1L of oil?
Re: Oil capacity and grades
Posted: Sun Oct 22, 2017 8:06 pm
by Frenchy
Odd when I eased off the filler pug on the diff fluid started to run out.As it was the front and my parking space is a little downhill, thought I try the rear on level ground,but the same,daft question but how can there be fluid above the filler level?
http://twiss.ddns.net/scuk/diy/16-trans ... g-diff-oil
Re: Oil capacity and grades
Posted: Mon Oct 23, 2017 8:29 am
by zook123
Might have a little water in it?
Re: Oil capacity and grades
Posted: Mon Oct 23, 2017 10:56 am
by ScottieJ
Frenchy wrote:Odd when I eased off the filler pug on the diff fluid started to run out.As it was the front and my parking space is a little downhill, thought I try the rear on level ground,but the same,daft question but how can there be fluid above the filler level?
http://twiss.ddns.net/scuk/diy/16-trans ... g-diff-oil
Easy it's not been filled on level ground. Tbh even if it is it's easy to overfill and get the bung in before that much runs out, I often give it a quick extra spurt of oil and then put the bung in.
Re: Oil capacity and grades
Posted: Mon Oct 23, 2017 10:57 am
by ScottieJ
zook123 wrote:Might have a little water in it?
It would be creamy and whiteish if it had water in.
Re: Oil capacity and grades
Posted: Mon Oct 23, 2017 2:20 pm
by Frenchy
No sign of anything else but fluid,I'm sure I read somewhere it shouldn't be "over filled".Should I take out the plug until it stops running or just leave it as it is? I've had the car two years and it doesn't appear to have made any problems.
Re: Oil capacity and grades
Posted: Mon Oct 23, 2017 2:38 pm
by SherwoodNash
ScottieJ wrote:
Easy it's not been filled on level ground.
Very astute Scottie, wish I'd thunk of that
Re: Oil capacity and grades
Posted: Mon Oct 23, 2017 3:33 pm
by ScottieJ
Frenchy wrote:No sign of anything else but fluid,I'm sure I read somewhere it shouldn't be "over filled".Should I take out the plug until it stops running or just leave it as it is? I've had the car two years and it doesn't appear to have made any problems.
Slightly over filled won't hurt at all, in fact it will help keep the diff cooler. It would take a LOT of fluid to really over fill a diff as you would have to fill the entire axle tubes first and it would all be leaking past the half shaft oil seals
If the oil looks good then just leave it as it is.
Re: Oil capacity and grades
Posted: Mon Oct 23, 2017 4:14 pm
by Frenchy
Thanks Scottie I'll leave well alone.